|
Featured in the Handyman Club of America Magazine
|
Featured in the Handyman Club of America Magazine - Page 7 |
|
Page 8 of 9
Step 24 - Corner Leg Support
Place a 19" cedar 2"x4" board in the four 45 degree corners of the bench. Toe-screw into the surface of the deck and into the frame of the bench using 2 1/2" trim head screws. |
Step 25 - Corner Frame Support
Measure and cut a double 2"x4" cedar board to be placed in the four 45 degree corners. Secure to each other, and then to the frame of the bench using 2 1/2" trim head screws. |
Step 26 - Bench Based Trim
Cut 18 22" cedar 2"x4" boards. Cut a 1 1/2" - 45 degree chamfer from each end. Position one board on each side of each leg and attach using 2 1/2" trim head screws. |
Step 27 - Bench Decking
Cut to fit four decking boards for each section of the bench. Start at one end of the bench and work your way around. Use the width of a deck screw as a spacer between deck boards. Attaching using 2 1/2" trim head screws. Predrilling is preferred. |
|
|
|
|
Printable Step by Step Instructions and Plans for the octagonal deck featured in the Handyman Club of America Magazine
The printable version of our instructions are in Adobe PDF format. You must have Adobe Reader to be able to view and print the plans. The Acrobat Reader is free from Adobe.
|
Showcase 
